![]() ![]() ![]() The bus termination might be installed by external 120 Ohm resistors placed in between the "CAN High" and "CAN Low" wire at both end points of the network (like shown by the picture above). ![]() all CAN slaves must have a different CAN node ID configuration.Įach CAN bus network must have bus terminators with 120 Ohm at both end points of the physical network. Each CAN node ID must be unique in the CAN network, i.e.If more than one CAN device has a fixed CAN bit rate configured, it must be the same for each of these CAN devices. At least one CAN device must have a fixed CAN bit rate configured.A CAN network has no(!) ring topology and there should be no(!) stub lines present. The CAN network has to be connected from one node to the other with a bus termination for each of the two end points.A CAN bus termination (of 120 Ohm each) must be present at the two physical end points of the CAN network.There are some important points which have to be taken into account by the wiring of a CAN bus network. What has to be taken into account concerning a proper CAN bus wiring as the base of a reliable CAN bus communication? Solution: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |